Pad Replacement & Guide 

The replacement pad for the 11" Waxcoa and PolishMaster orbital polishers are pad only without any hardware attached. The overall pad measures 10 3/4 inches across.      

The old pad must first be removed from the metal pan assembly.   The measurement of the metal pan than fits into the replacement pad cut-out should be 6 3/4 inches across. The metal pan must be cleaned of any adhesive and foam residue.  A good quality solvent or acetone should do the trick.  The new replacement pad must then be re-attached to the metal pan with a good quality contact cement either aerosol spray or liquid.  Allow the replacement pad to dry for at least 6-8 hours before use. 

If you have any questions concerning this procedure or about the replacement pads, please call us at 

(888) 282-8199 or (941) 485-8199.

Thanks.

Mark Supply, Inc.

Waxcoa/Polishmaster

Foam Pad & Contact Adhesive Kit

1- Foam Replacement Pad 

   1- 12oz Aerosol Adhesive